Yaesu G-450A Rotator control fail

Accidentally pulled the control cable plug out of the back of my rotator contor while cleaning up a cable mess behind my desk. Unfortunately the control was on at the time.
Not sure what damage I did but the control no longer lights up. Took the fuse out and checked with ohm meter and shows it was good. So here I sit with not being able to turn
my Hex Beam with it stuck in the SE position.


Found out the only damage was the dial light. I took small screw driver and pushed the pins on the connector of the rotor to reset them just and case and did same
with the rotor cable plug.  Rotor now turns and as said, only thing is the dial light which will involve taking front panel off rotor control to get to.

Leave a Reply